Best 9 Steps How To Put Fishing Line On A Closed Reel

Keeping your fishing line of top quality is impossible, so you need to figure out how to put fishing line on a closed reel.

For those who are not regular with fishing, it must be noted that the fishing line is faced with lots of things that deteriorate its quality quickly. And they deteriorate due to being exposed to elements such as:

Water
The Sun
Humidity

Re-spooling, retrieving, and even casting also take a toll on the fishing line. For this reason, you must change the line once in a while.

Our articles will give you simple instructions on how to put a fishing line on a closed reel.

9 Steps How to Put Fishing Line on a Closed Reel

People make use of different methods in putting fishing lines on closed reels. We will take a cursory look at some of these techniques. And the first technique we will look at entails the following:

Step One: Identifying the Line Capacity of Your Reel

The first step to putting a fishing line on a closed reel is checking your chosen reel’s line capacity.

You need to put the correct line on the reel because if you use the incorrect line, you will be unable to manage the line while the casting distance will be limited.

Step Two: Opening the Cover Off the Reel While Laying the Rod Flat

After identifying the line capacity, you are to unscrew the lid of your spin cast reel.

Understand that not all reels need to be unscrewed because some have a notch and pin that can be separated.

In addition, some spin cast reels have push buttons that instantaneously open up the covers once they are pressed.

Step Three: Remove Old Lines from the Reel

While some people keep a part of the old line to attach the new one, others prefer to take it off completely.

Step Four: Tying Your New Line to the Spool

At this point, it is up to you to learn how to put a fishing line on a closed reel to run the specific line that comes from the end of your rod through the eyelets or the hole in the cover.

It can be tied to the new line, and you can efficiently run it straight from the handle’s tip.

Some people may decide to take on the help of the rod guides; however, you will have to pull on it tightly once an arbor knot is made.

If you never threw away your old line, it can be used at this point as backing. Then, you need to tie the two lines together using a nail knot or two clinch knots.

Step Five: Covering the Reel

When you are done with the fourth step, you are to cover your reel by holding the line tightly as you put the cover back on.

In doing so, ensure that the reel’s cover does not pinch your line. You pull the line tightly after you place your lid back on.

Step Six: Reeling the New Line on the Reel

It will be carried out by laying the spool on the floor. It is crucial as it ensures your line comes off the spool precisely as it goes onto the reel.

In addition, this is a step that safeguards the line from getting twisted. Hold the line tightly with one hand and begin reeling the new line on the reel.

Additionally, you are to ensure you are maintaining maximum tension on your line to ensure you have a tight reel.

If your reel is not tight, you will encounter diverse casting issues. So, you must reel your line at a subtle yet steady pace.

Step Seven: Fill Your Spool to 1/8 Inch of Your Lid

When you get to the seventh step in learning to put a fishing line on a closed reel, you must not place any excessive line on your reel. Instead, open the cover of the reel every fifteen to twenty seconds.

It is done to make sure your reel runs smoothly with lines. It must be noted that the closed reel is known to hold fewer lines than all other types of reels.

However, ensure you do not pinch the line accidentally as you replace it with a newer line.

Step Eight: Running the Line and Tying Lures Using the Line Guides

With a good line guide, you must tie any lure of your choice. And you are to ensure you hold on to your reel during the casting process.

As you hold the reel, you can pin the line as it stays between your fingers.

Bear in mind that this process assists in keeping the line tight while you reel in, primarily when you use a light lure since it never inserts tension on your lines.

Step Nine: Eliminating Tangles and Twists from Your Line

In the final method, ensure there are no twists and tangles on your line while you reel it subtly and slowly.

Additionally, you can lay your line on the floor or a flat surface and ensure no obstacles are at the line’s end.

Other Methods

Another method, aside from the steps above, will take time to get done, but when you are finished, it can last up to twenty years.

You can begin with the spooling process and ensure that the line is fixed on the spool’s handle. It will ensure it goes directly toward the spool’s side once it gets tight enough.

Here, you will need to tie an overhand knot around the main line and enable six inches of tag end after your knot.

Then, you are to pull slacks through and be prepared to begin rewinding up towards the spool’s side.

Once all of the above is done, keep tension on your main line before wrapping it towards the handle of the spool’s side.

At this point, you will realize that the slacks in the main line are being taken by your knot to hold on tight.

With this, a line loop can be left from underneath where your knot falls through.

It will enable the swift removal of any excess line, and you can re-tie later without needing to pull some more off.

One can always tie another overhand tag end knot when you get near where you originally started. All extra main lines that get past the knot will be cut off.

FAQS (Frequently Asked Questions)

Why should you learn to put fishing line on a closed reel?

Even though you know how to attach fishing lines to closed reels, you might need help understanding why you should. Simply put, a closed reel is an excellent choice for anglers just starting to catch fish.
Moreover, the closed reel or face fishing pole is easy to use and isn’t complicated to set up. You don’t need to buy expensive parts to make one, and you can use them in various fishing areas.

How do you put fishing line on a reel without tangling?

To avoid tangling your fishing line while spooling it onto a reel, make sure the line is coming off the spool in the same direction as the spool is turning. You can also use a pencil or something similar to create some tension on the line as you spool it onto the reel. Additionally, be sure to fill the reel to its capacity without overfilling it.

Why does fishing line get tangled?

Fishing line can become tangled for several reasons, including poor casting technique, not properly spooling the reel, or using a low-quality line that is prone to tangling. Additionally, wind and other environmental factors can cause line tangles.

How do you spool a closed spinning reel?

To spool a closed spinning reel, first open the bail and thread the line through the guides on the rod. Next, tie the line onto the spool with an arbor knot. Hold the spool and begin winding the line onto it, making sure the line is coming off the spool in the same direction as the spool is turning. When the spool is full, cut the line and close the bail.